NOTE P.D.G du 27/05/2020 * PACKER BIMBAR
22 juin 2020 par Petrometalic - Web
- Depuis 1975, la SAS PETROMETALIC fabrique l’Obturateur Bimbar.
- Conçu par notre Bureau d’Etudes, en collaboration avec la Sté BERGOUGNAN, nous avons toujours respecté les normes définies à l’époque.
- Les Sociétés KLEBER, puis TRELLEBORG ont continué cette fabrication complexe avec la même rigueur. Chaque longueur produite subit des tests sévères et les non-conformités mises en décharge.
- De notre côté, les embouts sont en Acier spécial, les lignes intérieures en INOX 316L, raccords dudgeonnés, les soudures manuelles, Essais en pression avant expédition et marquage individuel.
L’Obturateur Bimbar est fait pour durer. (20 injections et plus)
- La condition : respecter les règles d’utilisation.
- Diam Packer = Choix adapté
- Forage = Préférer Gainé sinon attention aux sols mous, fer, silex, graisses…
- Pression de gonflage respectée = toujours supérieure à la pression d’injection
- Attention à la colonne d’eau, puit artésien …. (10 m = 1 Bar)
- Dégonflage TOTAL avant sortie du Packer.
- Nettoyage intégral, après utilisation et conservation sous abri sec
- Le gonflage à l’eau claire. Les gaz neutres, possible (Air-Azote) exclure les autres.
- Respecter les règles de sécurité :
Déjà vu sur chantier :
USA : gonflage oxygène = explosif
NICE : sur-gonflage obturateur diam 130 = Canon
- Anticiper les commandes – Stock lourd.
WEB : www.petrometalic.com
A consulter News et Catalogues Techniques
Philippe MAZUREL - CEO
NOTE P.D.G du 27/05/2020 * PACKER BIMBAR
Since 1975 SAS PETROMETALIC has manufactured the Packer Bimbar.
Désigned by our design office in collaboration with the Cie BERGOUGNAN, we have always respected the standards defined at the time.
The companies KLEBER then TRELLEBORG continued this complex manufacturing with the same rigor.
Each length produced undergoes severe tests and non-conformities landfilled.
On our end, the end caps are made of special steel, the interior lines are made of 316L stainless steel, connection dudgeoned, the manual welds, pressure tests before
shipment and individual marking.
The Packer Bimbar is made to last (20 injections and more)
The condition : respect the rules of use.
- Diam Packer = Adapted choice
- Drilling = Prefer protected drill otherwise beware of soft soils, iron, flint, oils….
- Inflation pressure respected = always higher than the injection pressure
- Beware of the water column, artesian well…(10 m = 1 Bar)
- Total deflation before leaving the packer.
- Complete cleaning, after use and storage under dry shelter
- Prefer inflation with clear water. Neutral gases, possible (Air-Nitrogen) exclure the others.
- Respect the safety rules :
Already seen on site :
USA : oxygen inflation = explosive
NICE : shutter over-inflation diam 130 = GUN
- Anticipate orders – Heavy stock
WEB : www.petrometalic.com
To consult News and Technical Catalogs
Philippe MAZUREL - CEO